Previous Article | Next Article ![]()
Journal of Clinical Microbiology, July 2004, p. 3284-3287, Vol. 42, No. 7
0095-1137/04/$08.00+0 DOI: 10.1128/JCM.42.7.3284-3287.2004
Copyright © 2004, American Society for Microbiology. All Rights Reserved.
Department of Medical Microbiology and Hospital Epidemiology, Medical School Hannover, 30625 Hannover,1 Asklepios Fachklinik, 82131 München-Gauting, Germany2
Received 13 January 2004/ Returned for modification 1 March 2004/ Accepted 17 March 2004
|
|
|---|
|
|
|---|
Biochemical profiling included testing for growth on 5% sodium chloride and growth on citrate as the sole carbon source as suggested by Yakrus and colleagues (13). Briefly, bacteria were precultured in liquid medium using mycobacterial growth indicator tubes (MGIT) (Becton Dickinson, Oxford, United Kingdom). Positive MGIT cultures were subcultured with 0.1 ml of a 1:10 dilution on Lowenstein-Jensen selective medium (L-J) containing 5% NaCl (Remel, Lenexa, Kans.). Utilization of sodium citrate was determined as described by Silcox et al. (8). Briefly, a basal medium was prepared by dissolving 2.4 g of (NH4)2SO4 (Merck, Darmstadt, Germany), 0.5 g of KH2PO4 (Merck), and 0.5 g of MgSO4 · 7H2O (Merck) in 950 ml of distilled water; the pH was adjusted to 7.0, and after adding 20 g of Noble agar (Difco Laboratories, Detroit, Mich.), the mixture was autoclaved. Sodium citrate (5.6 g) (J. T. Baker, Deventer, The Netherlands) was dissolved in 50 ml of distilled water, filter sterilized, and added aseptically to the cooled basal medium. Plates were inoculated with 0.1 ml of a 1:10 dilution of a MGIT culture and incubated for 3 weeks.
Cultures on L-J with high (5%) NaCl concentration and on plates with citrate revealed that 27 strains, including the M. abscessus reference strain, grew on L-J with 5% NaCl but failed to grow on sodium citrate medium (Table 1). In contrast, 11 strains, including the M. chelonae reference strain, grew on sodium citrate medium but not on L-J with 5% NaCl (Table 1). We controlled for growth by inoculating bacteria simultaneously on standard L-J slants and plating them on 7H10 complete medium (Difco Laboratories). Thus, biochemical profiling allowed unambiguous identification of M. abscessus and M. chelonae; yet it was time-consuming, since at least 3 weeks of growth at 37°C was required.
|
View this table: [in a new window] |
TABLE 1. Comparison of bacterial strains by biochemical profile, hsp65 gene fragment restriction, and LightCycler 16S rRNA and hsp65 gene fragment analyses
|
The initial study by Telenti and colleagues showed that for M. abscessus restriction with BstEII yields a 245-bp fragment and a 200-bp fragment and restriction with HaeIII results in a 160-bp fragment and a 60-bp fragment. For M. chelonae, restriction with BstEII yields a 325-bp fragment and a 140-bp fragment and restriction with HaeIII results in a 210-bp fragment (12). In this study, all M. chelonae isolates but only 15 of 27 M. abscessus isolates showed these patterns (Table 1). For the remaining 12 strains, restriction with BstEII yielded the expected 245-bp and 200-bp fragments but restriction with HaeIII resulted in a 210-bp fragment and a 60-bp fragment.
Devallois and colleagues confirmed this alternative HaeIII restriction pattern for M. abscessus and suggested that M. abscessus type I and M. abscessus type II should be differentiated on that basis (3). Subsequently, Ringuet and colleagues attributed this variation to a T
C single-nucleotide polymorphism at position 542 in the hsp65 gene, affecting an HaeIII restriction site (7). However, M. abscessus type II is difficult to distinguish from M. chelonae because it features only the 60-bp fragment in addition to the common 210-bp fragment.
Finally, we sought to develop an easy and rapid procedure based on LightCycler technology to resolve these problems. First, the entire 439-bp fragment of the hsp65 gene was sequenced by using the forward amplification primer (12). Based on the alignment results of all 38 strains, FRET probes LC 98 (GAG CCT GGG CAA GCA CGG TGG-fluorescein) and LC 99 (LightCycler Red 640-GGT GGT GGT GCC GTC ACC) were chosen for subsequent LightCycler analyses (Fig. 1). Probes were designed to differentiate between M. abscessus type I, M. abscessus type II, and M. chelonae. Yet M. abscessus type I, M. abscessus type II, and M. chelonae could not be unambiguously distinguished from other mycobacteria because of limited variation within this region. Therefore, we included an M. chelonae-M. abscessus group-specific FRET probe, targeting the variable region A of the 16S rRNA gene. A 1,000-bp fragment of the 16S rRNA gene was amplified by using primers LC1 (GAG TTT GAT CCT GGC TCA GGA) and LC4 (TGC ACA CAG GCC ACA AGG GA) as described before (6). The melting profile of the 1,000-bp fragment was analyzed by using the FRET probes LC 68 (GGC CGC GGG CCC ATC CCA CAC-fluorescein) and LC 86 (LightCycler Red 705-CAA AAG CTT TGC ACC ACT CAC).
|
View larger version (15K): [in a new window] |
FIG. 1. Alignment of 51-bp fragments of the hsp65 genes from M. chelonae, M. abscessus type I, and M. abscessus type II. Comparison of 38 strains revealed three different nucleotide sequences, corresponding to M. chelonae, M. abscessus type I, and M. abscessus type II. Nucleotide polymorphisms are in bold and underlined. Specific melting point temperatures (Tm) of the FRET probe from the various sequences are given on the right. The chosen FRET probes are shown. The HaeIII restriction site that is affected by a nucleotide polymorphism is also shown.
|
The 439-bp fragment of the hsp65 gene and the 1,000-bp fragment of the 16S rRNA gene were amplified simultaneously (multiplex PCR). Figure 2 shows subsequent melting point analyses in the F2 (640 nm) and F3 (705 nm) channels. Targeting region A of the 16S rRNA gene generates identical melting points at 66°C for M. chelonae and M. abscessus (Fig. 2B). Specificity of the M. chelonae-M. abscessus probe was confirmed by melting point analysis of 33 mycobacteria, including M. chelonae and M. abscessus (Table 2). Except for M. chelonae and M. abscessus, 23 of 31 species showed melting points at temperatures between 43.4 and 55.4°C (mean, 51.0°C; standard deviation, 3.0°C), which are well below the specific melting point of 66°C for the M. chelonae-M. abscessus group. For eight species, melting points were not detectable above 38°C.
![]() View larger version (20K): [in a new window] |
FIG. 2. (A) Melting point analysis of the hsp65 gene fragment in the F2 channel (640 nm). Data for M. abscessus type I, M. abscessus type II, M. chelonae, and the control (H2O) are shown. Amplification and detection of DNA were performed with primer pairs Tb11 and Tb12 and FRET probes LC98 and LC99. The melting point for M. chelonae was 58°C, for M. abscessus type I it was 62°C, and for M. abscessus type II it was 67°C. (B) Melting point analysis of the 16S rRNA gene fragment in the F3 channel (705 nm). Data for M. abscessus type I, M. abscessus type II, M. chelonae, and the control (H2O) are shown. Amplification and detection of DNA were performed with primer pairs LC1 and LC4 and FRET probes LC68 and LC86. Melting points for M. chelonae, M. abscessus type I, and M. abscessus type II were all at 66°C.
|
|
View this table: [in a new window] |
TABLE 2. Melting point analysis of the 16S rRNA gene fragment in the F3 channel (705 nm)
|
In this study we developed a LightCycler multiplex PCR based on analysis of the 16S rRNA gene and the hsp65 gene for rapid differentiation between M. abscessus type I, M. abscessus type II, and M. chelonae. The advantage of this LightCycler protocol is the simultaneous detection of two different genomic regions, since neither LightCycler analysis of the hsp65 gene nor that of the 16S rRNA gene alone leads to unambiguous identification of these organisms. In addition, the ability to discriminate between M. abscessus types I and II may be useful for a preliminary epidemiological analysis in clinical infection. This LightCycler protocol provides an alternative method for differentiation between the closely related species M. abscessus and M. chelonae and complements previously published LightCycler-based procedures for the identification of mycobacteria (6, 9).
This work was funded in part by the Niedersächsische Verein zur Bekämpfung der Tuberkulose, Lungen- und Bronchialerkrankungen.
|
|
|---|
This article has been cited by other articles:
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Copyright © 2009 by the American Society for Microbiology. For an alternate route to Journals.ASM.org, visit: http://intl-journals.asm.org | More Info»