Previous Article | Next Article ![]()
Journal of Clinical Microbiology, May 2008, p. 1628-1630, Vol. 46, No. 5
0095-1137/08/$08.00+0 doi:10.1128/JCM.02486-07
Copyright © 2008, American Society for Microbiology. All Rights Reserved.

Department of Pathology and Laboratory Medicine, Emory University School of Medicine, Atlanta, Georgia,1 Department of Behavioral Science, Rollins School of Public Health, Atlanta, Georgia,2 Center for AIDS Research, Emory University, Atlanta, Georgia3
Received 28 December 2007/ Returned for modification 13 February 2008/ Accepted 3 March 2008
|
|
|---|
|
|
|---|
There are numerous reports supporting the role of PCR in the diagnosis of T. vaginalis infections from genital specimens; these reports have shown that the detection of T. vaginalis DNA by PCR is significantly more sensitive than both culture and wet mount examination (1, 4, 6, 12, 14, 15). We have previously reported that vaginal swabs collected with the BDProbeTec dry swab system were a reliable specimen for PCR testing and allowed the detection of Chlamydia trachomatis, Neisseria gonorrhoeae, and T. vaginalis from a single specimen (1). For clinical studies using urine specimens, our procedure for stabilizing T. vaginalis was cumbersome and involved adding an aliquot of urine to Fuji medium (Remel, Lenexa, KS), to prevent autolysing of the T. vaginalis organisms. In this report, we describe a simple method for stabilizing T. vaginalis DNA in urine samples by use of the Becton Dickinson urine preservative transport (UPT) kit, which is routinely used for Chlamydia trachomatis and Neisseria gonorrhoeae testing in clinical laboratories. The use of UPT for T. vaginalis testing would be easy for clinics and laboratories and would still allow testing for C. trachomatis, N. gonorrhoeae, and T. vaginalis DNA from a single specimen.
|
|
|---|
Trichomonas vaginalis real-time PCR assay. Urine samples were processed either directly or with the BD UPT kit (Becton Dickinson, Sparks, MD) (see below for details of study design). The UPT tubes contain 50 µl of a <742.5 mM solution of potassium-EDTA. For samples processed with the UPT, 3 ml of urine was added to the UPT and, after storage for the designated period of time, the specimen was processed following the manufacturer's recommendations. Briefly, the sample was heated to 114°C for 10 min, cooled for 15 min, and centrifuged at 3,000 x g for 30 min. The pellet was resuspended in 1.5 ml of the Becton Dickinson dimethyl sulfoxide buffer. A 5-µl aliquot was used for PCR testing. For samples processed without the UPT, 3 ml of urine was heated directly and the above-described procedure was followed. The T. vaginalis real-time PCR assay was performed as previously described (1).
Study design. The study was designed to determine how long the T. vaginalis DNA would remain stable at 4°C or room temperature before it was added to the UPT and then to determine how long the DNA was stable once in the UPT (Table 1). There were four arms to the study, with each containing 10 different urine samples. An aliquot of each urine sample was processed within 5 min of spiking with T. vaginalis and served as the time zero specimen. For arm 1, each of the 10 urine samples was stored at 4°C and an aliquot of each was added to UPT 1 h, 6 h, and 24 h after spiking; once in the UPT, an aliquot was processed 1 day, 3 days, 7 days, and 30 days later. For arm 2, each of the 10 urine samples was stored at room temperature (20 to 22°C) and an aliquot of each was added to UPT 1 h, 6 h, and 24 h after spiking; once in the UPT, an aliquot was processed 1 day, 3 days, 7 days, and 30 days later. For arm 3, the 10 urine samples were stored at 4°C without UPT and an aliquot was processed 1 day, 3 days, 7 days, and 30 days later. For arm 4, the 10 urine samples were stored at room temperature (20 to 22°C) without UPT and an aliquot was processed 1 day, 3 days, 7 days, and 30 days later. All specimens from a given time point were processed together and tested in the same run. All runs included positive and negative controls; the positive control CT values fell within a range of 30.6 to 31.7.
|
View this table: [in a new window] |
TABLE 1. Study designa
|
|
|
|---|
The results of the four arms were initially analyzed based on the qualitative result of positive or negative results of tests for T. vaginalis DNA. In comparing arms 3 and 4 (Table 2), storage at room temperature without the use of UPT led to a high number of aliquots negative for T. vaginalis DNA compared to storage at 4°C; the dropout of positive results increased with longer storage time. When stored at 4°C, only 1 of the 40 aliquots was negative at the four time points tested; however, when stored at 20 to 22°C, a total of 10 of the 40 aliquots were negative. For arms 1 and 2, with the use of UPT, all aliquots remained positive even with delays of up to 24 h prior to putting samples into UPT and after storing in the UPT for up to 30 days.
|
View this table: [in a new window] |
TABLE 2. Results for urine samples stored at 4°C or room temperature without addition to the UPT
|
1 log10 (
3.3 cycles) was seen for three different time points when aliquots were stored with UPT at 20 to 22°C, compared to none for samples held at 4°C. For specimens stored without the use of UPT (arms 3 and 4) (Table 5), there was a 0.6-cycle increase in CT for aliquots held for 1 and 3 days at 4°C; this increased to 3.6 and 2.3 cycles for aliquots held 7 and 30 days, respectively. An even more pronounced increase in CT value was seen for specimens stored at room temperature without the use of UPT, with the most dramatic increases being observed at 7 and 30 days. The rise in CT value observed for aliquots held 7 and 30 days at room temperature would correlate with a drop in sensitivity of 1.9 to 2.0 log10. |
View this table: [in a new window] |
TABLE 3. Results for arm 1 (4°C)
|
|
View this table: [in a new window] |
TABLE 4. Results for arm 2 (20 to 22°C)
|
|
View this table: [in a new window] |
TABLE 5. Results for arms 3 and 4
|
|
|
|---|
Overall, there was better stability of T. vaginalis DNA when urine specimens were stored at 4°C than when they were stored at 20 to 22°C and when the UPT system was used. Based on qualitative results (positive or negative for T. vaginalis DNA), it appeared that T. vaginalis DNA in urine was stable at 4°C for 30 days without the use of UPT, as 39 of the 40 aliquots remained positive over that time period. However, when assessing the rise in CT value when specimens were stored at 4°C, it appears that there was a loss of sensitivity of the PCR assay when aliquots were held for more than 3 days without the use of UPT, with a rise in the mean CT value of 2.3 to 3.6 cycles. For specimens stored at room temperature without the use of UPT, the rise in CT value for urine aliquots held for more than 3 days was even more pronounced, at 4.4 to 4.6 cycles. To better assess what rise in CT value was important, we reviewed data from our previously published study (1), in which urine samples were collected from women and tested for T. vaginalis DNA. A total of 52 specimens were positive for T. vaginalis DNA. The mean CT observed for specimens that were both PCR and culture positive for T. vaginalis was 26.2, with a range of 18.3 to 39.1, while specimens that were culture negative and PCR positive had a mean CT value of 33.7, with a range of 23.7 to 39.8 (1). In that study, there were no data available on whether the women were asymptomatic or symptomatic. Seven of the 52 (13.5%) positive specimens had a CT value of >36. Based on these data, a significant number of clinical specimens would be expected to have a high CT value, so a rise in CT value of greater than 2 cycles may lead to a loss in clinical sensitivity. Using this 2-cycle rise in CT value as a general guide, T. vaginalis DNA in urine was stable when stored without UPT at 4°C for about 3 days and at room temperature for only 1 day. For specimens placed in UPT within 24 h (times of 1, 6, and 24 h) of collection, the DNA was stable for up to 30 days when stored at 4°C. For specimens stored at room temperature, ideally the urine should be added to the UPT within 1 hour of collection, which can be done at the site of collection. DNA then remained stable for up to 30 days. When storing specimens at room temperature, a delay of 24 h prior to adding the aliquot to UPT led to an unacceptably high loss of assay sensitivity.
Shafir et al. (10) recently studied the effect of processing time delay on culture and PCR testing for T. vaginalis. Samples were held for various times at either room temperature or 37°C. The sensitivity of culture dropped off dramatically after 30 min for samples held at either 37°C or room temperature. For PCR testing, the sensitivity of the test began to drop off after 60 min of storage at either 37°C or room temperature. Our results were similar in that the sensitivity of PCR testing began to drop off after 1 day of storage at room temperature without the use of UPT.
In summary, the use of the UPT is an effective method to stabilize T. vaginalis DNA in urine for PCR testing. Ideally, urine should be added to the UPT within 1 hour of collection or stored at 4°C for up to 3 days before adding the urine to the UPT. Under these conditions, once in the UPT, the DNA is stable for up to 30 days. The use of the UPT allows laboratories to easily test for C. trachomatis, N. gonorrhoeae, and T. vaginalis DNA from a single specimen.
Published ahead of print on 12 March 2008. ![]()
|
|
|---|
This article has been cited by other articles:
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Copyright © 2009 by the American Society for Microbiology. For an alternate route to Journals.ASM.org, visit: http://intl-journals.asm.org | More Info»